QUESTION: 37

What is an available command on an Aruba AOS-CX switch that would back up the secondary image to a secure remote repository?

backup secondary sftp://[email protected]/GL.10.04.0003.swi
copy secondary sftp://[email protected]/GL.10.04.0003.swi
copy sftp://[email protected]/GL.10.04.0003.swi secondary
copy secondary tftp://[email protected]/GL.10.04.0003.swi

Answer(s): B

Reveal Solution Next Question

QUESTION: 38

Refer to the exhibit.

The above output is the result of issuing the command show system resource-utilization. What command should be used to enable terminal output line by line or page by page?

The command page
The command terminal length 30
The command more
The command less

Answer(s): A

Reveal Solution Next Question

Refer to the exhibit.

You are in the process of configuring VSF between Access-1 and Access-2. Access-1 has been configured as the VSF Master.

What is a valid configuration for Access-2 to join the VSF stack?

Access-2# configure
Access-2(config)# vsf member 1
Access-2(config)# vsf renumber-to 2
Access-2(vsf-member-1)# link 2 2/1/28
Access-2(vsf-member-1)# exit
This will save the VSF configuration and reboot the switch.
Do you want to continue (y/n)? y
Access-2# configure
Access-2(config)# vsf member 2
Access-2(vsf-member-1)# link 2 1/1/28
Access-2(vsf-member-1)# exit
This will save the VSF configuration and reboot the switch.
Do you want to continue (y/n)? y
Access-2# configure
Access-2(config)# vsf member 2
Access-2(vsf-member-1)# link 1 1/1/28
Access-2(vsf-member-1)# exit
This will save the VSF configuration and reboot the switch.
Do you want to continue (y/n)? y
Access-2# configure
Access-2(config)# vsf member 1
Access-2(vsf-member-1)# link 1 1/1/28
Access-2(vsf-member-1)# exit
Access-2(config)# vsf renumber-to 2
This will save the VSF configuration and reboot the switch.
Do you want to continue (y/n)? y